Swather BeltingThe basic windrower/swather belt is a 1 ply rubber coated canvas type of the slat series used by original manufacturers of swather belting. A majority of windrower/swather belts on machines in the Australian market are either 42” wide smooth back belt or 41.6" wide belt with a vulcanized V Guide on the underside edge. The list of makes and models of available windrow/swather belting is extensive. Centre delivery belts/mats are also available for the most popular models. |  |
When ordering windrower/swather belting you will need to supply the following information:
- The overall width of belt
- The overall length of belt - to the closest foot - so a belt slightly longer than required can be supplied to ensure easy fitting
- Are joiners required?
Installation
- Install heads of joiner belts so they face the direction most frequently travelled.
- Remove excess material off the flap to prevent a noisy slapping effect when operating. Trim tail end flaps to 1/4" after filling and tightening joiners.
- There is a tendancy for belts to creep towards the slack side of roller. When adjusting the roller carriage always keep the rollers parallel with each other.